4
3.2Switch Box
The switch box is located in the heat pump. It can be accessed by removing the lower front cover.
The switch box contains the supply connection terminals, as well the power contactors, the soft starter unit and the heat pump manager.
The heat pump manager is a convenient electronic regulation and control device. It controls and monitors the entire heating or cooling system on the basis of the external temperature, includ- ing hot water preparation and safety systems.
The customer must install the external temperature sensor, which is included in the scope of supply of the heat pump control- ler together with the necessary fixing accessories.
The enclosed operating instructions describe the function and use of the heat pump manager.
3.3Accessories Pack
Contents:
2Sealing rings for duct connection
31" connecting hoses
31" double nipples
61" flat gaskets
11" sealing plug
1Hose nozzle for filling and drain cock
2Fixing brackets
2
28 x 80 screws
4M4 x 8 screws
1External sensor
1
14.5 x 50 screws
4 Transport
ATTENTION!
When transporting the heat pump, ensure that it is not tilted more than 45° (in any direction).
Use a wooden pallet for transporting the heat pump to the final in- stallation location. The basic device can be transported with a lift truck, hand truck or by means of 3/4" pipes fed through the holes in the base plate or frame.
ATTENTION!
The heat pump and the wooden pallet are only joined by the packing film.
Before using the holes in the frame, it is advisable to remove each of the side panel assemblies. This is done by loosening each of the two screws at the base and then withdrawing the panels by unhooking them from above. Rehang the panels by gently pushing them in an upwards direction.
English
Opening the cover
Closing the cover
www.dimplex.de |