5
English
5 Set-UP
5.1General Information
The heat pump is designed for installation in a corner. Other in- stallation locations are also possible in combination with an air duct (available as an accessory) on the air outlet side.
The unit must be installed indoors on a level, smooth and hori- zontal surface. The entire base of the frame should lie directly on the floor to ensure a good soundproof seal. If this is not the case, additional sound insulation measures may be necessary.
The heat pump must be installed so that maintenance work can be carried out without being hindered. This can be ensured by maintaining a clearance of 1 m in front and to the left of the heat pump. The side panel assemblies must not be covered by connecting pipes.
P
P
Never install the device in rooms subject to high humidity. Con- densation can form on the heat pump and air circuit if the humid- ity exceeds 50 % and the external temperature is below 0 °C.
If the heat pump is installed on an upper storey, the
5.2Condensed Water Pipe
Condensed water that forms during operation must be drained off
5.3Sound
To prevent
Installed air ducts should be
If both air openings are connected directly to a wall opening, the ventilator terminals can be reversed from a delta to a star con- nection (see information in the ventilator terminal box).
6 Installation
6.1General Information
The following connections need to be established on the heat pump:
Fresh and exhaust air
Flow and return flow of the heating system
Condensate outflow
Outflow for the pressure relief valve
Power supply
6.2Air Connection
ATTENTION!
Do not restrict or block the area around the air intake or outlet.
The air intake opening of the device is solely designed for direct connection to a wall opening. The wall opening can be provided with air duct and sealing collar for this purpose. See the illustra- tion in the appendix under Installation Dimensions.
The glass fibre reinforced concrete air ducts offered as accesso- ries are
The sealing collar is used to seal the air ducts on the heat pump. The air ducts are not screwed directly onto the heat pump. Only the rubber seal comes into direct contact with the heat pump when the system is installed correctly. This guarantees easy as- sembly and disassembly of the heat pump and also ensures that
It must also be ensured that the interior side of the wall opening is lined with thermal insulation to prevent the wall from becoming cold and to prevent moisture from penetrating the wall. The en- closed fixing accessories can be used for attachment to the wall.