Testing your system When you have aligned your dish antenna to the azimuth and elevation angles shown on the Install pane:
1.Highlight the Signal tab.
2.Use the 
button to highlight the Source
3.Signal quality is indicated by a scale at the bottom of the pane and with an audible indication. The frequency and tempo of the tone increase with signal strength.
SIGNAL STRENGTH |
| Thu, Jun 14 | 4:14 PM |
Install |
|
|
|
Signal | Signal Strength |
| |
VCR | Source | Transponder |
|
Prefs |
| ||
|
|
| |
Test | Satellite 101)(A) | 04 |
|
New Card |
|
|
|
Upgrades | Status: Unlocked |
| |
Features | Current: 95 | Highest: 95 |
|
Watch TV |
|
|
|
Main Menu |
|
|
|
4.Highlight the Transponder
5.You may need to select another transponder to achieve the highest signal indication.
6.Select the transponder providing the best signal.
7.Use the 
button to highlight the Test tab.
8.Highlight Begin Test and press the SELECT button.
Results appear within a few seconds and should resemble those in the figure. If your test results are much different from those shown in the figures, or you receive no signal indication, refer to page 6.
SYSTEM TEST |
| Wed, Jun 13 | 10:14 PM |
Install |
|
|
|
Signal |
| System Tests |
|
VCR | Begin Test | Xponder Test |
|
Prefs |
| ||
|
|
| |
Test | Version | : 5317.6 |
|
New Card |
| ||
Wink Version | :0.0.0.75 |
| |
Upgrade |
| ||
Signal | :OK |
| |
Features |
| ||
Tuning | :OK |
| |
Watch TV | Phone | :OK |
|
Main Menu |
| ||
Access Card | :OK |
| |
|
| ||
|
| (ID | |
| Front Panel | :OK |
|
To perform the Transponder test:
1.Move the highlight to the Xponder Test
2.Press the SELECT button.
Getting started | 5 |
