Using the Remote
Using Direct Entry
1.Turn on the component to be programmed.
2.Look up the brand and code number(s) for the component on the code list in the section “Remote Control Codes” on the following page.
3.Press and hold the remote control button you want to program.
4.Enter the code from the code list.
5.Release the button, and then press ON•OFF to see if the component responds to the remote control commands. If it doesn’t, try pressing the component button and then ON•OFF again.
6.If you get no response, repeat these steps using the next code listed for your brand until the component responds to the remote control commands.
Using the Remote to Control a
Component
Once the remote has been programmed successfully, you are ready to use it to control your components, such as a VCR, DVD player, or laserdisc player.
To operate the component:
1.Press the component button (VCR1, VCR2, DVD, or AUX) to set the remote to control the component.
2.Press ON•OFF to turn the component on or off.
3.Use the remote control buttons that apply to that component.
This remote control may not operate all models of the brands that are shown. Use the codes shown in this manual, or on the sheet packed with your remote control.
Use the AUX button to control a separate satellite receiver, if necessary. Do not reprogram the DIRECTV button.
Chapter 2 | 23 |
