Dish Network 104333 CHANGING THE REMOTE CONTROL ADDRESS

CHANGING THE REMOTE CONTROL ADDRESS

Note: Do not change the address of the remote unless absolutely

necessary, because the remote cannot control the receiver if the two

devices have different ad dresses. If you start doing this pro ce dur e and

then do not press any button for 20 seconds, the remot e will end the

procedure. Just start over again.

Note: This procedure shows examples of menu options. The options

that you see may differ.

8.If the code you entered does not work, repeat steps 3 through 7

using another code from the tables.

9.If you have tried all of the codes listed for the device without

success, or if you cannot find the device brand name in the

tables, see Device Code Scan on page20.

1.Display the Important System Information menu.

Note the Remote Address shown on this menu.

To do this:

Either: Press the System Information

button.

or: a) Press the Menu button.

b) Select the System Setup option.

Note: This step does not apply

to some receivers.

c) Select the Installation option.

d) Select the System Info option.

or:

2.Press and hold the SAT mode button about three

seconds, until all the mode button backlights

come on, and then release the SAT button.

3.Use the number buttons to enter a number

from 1 to 15. The SAT mode button backlight

will blink off aft er you enter each digit, and then

come on again.