Dish Network 104333 warranty Uhf

When you	You may be trying to	Remember that the remote control uses
press a button	control a device other	IR signals to control devices other than
on the remote	than the receiver,	the receiver. IR signals travel only
control, the	without pointing the	40 feet or less, and cannot go through
device does	remote control	walls or other solid objects. You must
not do what	directly at the device.	point the remote control directly at the
you expect.		device, with no objects blocking the line
	The remote control	of sight.
	may be missing	If the batteries are missing or dead, insert
	batteries, the
	batteries may be	fresh AAA-size batteries.
	incorrectly placed in	If the remote has fresh batteries, check
	the remote, or the	whether they are placed according to the
	batteries may be	label diagram. If not, remove them and
	weak or dead.	place correctly.
	The remote may not	Make sure to set the remote to the mode
	be set to the mode	that matches the device that you want to
	that matches the	control.
	device you want to	Make sure to set up the remote to control
	control.
	The remote may not	all the devices that you want to operate.
	be set up to control
	the device.
The system	The extenders use	Temporarily stop using the extenders,
uses infrared	UHF signals to	to see whether this eliminates the
(IR) remote	transmit signals from	interference. If the extenders are the
control	one room of the	source of the interference, you will have
extenders	building to another.	to avoid using them whenever you do not
(called	These signals may be	want interference with other devices that
“pyramids”).	causing the	use UHF. This is because UHF signals
Electronic	interference.	travel 100 feet or more, and go through
devices exhibit		walls and other solid objects.
ultra-high
frequency
(UHF)
interference.
The system	The IR sensor on the	Make sure the extender that receives the
uses infrared	extender that	signal from the remote control is facing
(IR) remote	receives the remote	the right way, so that the IR sensor can
control	control signals may	receive the remote control signals.
extenders	not be facing the	Make sure the IR cable on the extender
(called	remote control.	that sends the signal to the receiver is
“pyramids”).	The IR cable on the	right in front of the IR sensor on the
The IR remote	extender that sends	receiver front panel, so that the receiver
control	the signal to the	IR sensor can receive the signals.
extenders do	receiver may not be	If doing the above does not solve the
not seem to	right in front of the	problem, contact the manufacturer of the
work.	IR sensor on the	extenders for help.
	receiver front panel.

104333 27