Dish Network 32.0, 176842 manual Or Volume

What’s	What’s Wrong	What You Can Do
Happening
Your receiver is	• The remote control	• Make sure the remote control is in the
not responding	is in the wrong	correct mode. For example, if you want
to your linked	mode.	to control the ViP922 receiver, put the
remote control		remote control in SAT mode (see
at all.		Remote Control Modes on page 1).
	• You might be	• Make sure you are using the correct
	using the wrong	model of remote control.
	remote control
	(use only 30.0- or
	32.0-model DISH
	Network remotes).
	• Your batteries are	• Change the batteries as described on
	depleted.	page C-1.
When you press	• The remote control	• See Setting Up for Other Equipment on
the remote	mode set to control	page 2.
control MUTE	volume (TV or
or VOLUME	AUX) may not be
button, nothing	set up correctly.
happens.	• Maybe you are	• Set up the remote control to operate
	trying to control	either the TV volume or audio receiver
	TV volume, but	or amplifier volume, whichever you
	you set up the	want. SeeSee Switching Between TV
	remote to control a	and Amplifier Volume Control on page
	tuner or amplifier	8.
	in AUX mode.
Your UHF-2G	You may be	• Make sure the UHF-2G remote antenna
remote control	experiencing	is connected to the receiver’s rear panel
does not work	interference from	and is not touching anything else. It
well when far	objects or devices	should be tightened only by hand.
away from your	near your receiver’s	• Vary the tilt angle of the receiver's
ViP922 DVR	remote antenna.
		UHF-2G antenna. Locate the remote
receiver.
		antenna tip away from other electronic
		equipment or metal surfaces, even if
		separated by wooden shelving.
		• Move the ViP922 receiver to a different
		location. For best results, place the
		receiver as high as possible, above all
		other equipment in your rack or
		entertainment center.
		• Place the UHF-2G antenna outside the
		rack or entertainment center and away
		from other equipment by using the
		optionally available special cable to
		connect it to the back of the receiver.
		• Move any nearby antenna or radio
		equipment away from the UHF-2G
		remote antenna. For example do not
		place an over-the-air antenna, WiFi,
		Bluetooth, or Zigbee device on your
		receiver or near the remote antenna.
Your INPUT/	• Your receiver isn’t	• Select the MODE control on the front
Swap PIP	in Solo PIP (Single	panel to switch to Solo PIP mode (the
(Picture-In-	User) mode, or	amber light indicates the mode), press
Picture) button	your remote is not	SAT on the remote control and then try
isn’t working.	in SAT mode.	the INPUT/Swap PIP) button again.

14