11
DISCRETE CODES FOR LEARNING REMOTES
Note: Discrete codes are only used by IR remotes (either the TV1
remote or a universal remote).
Remote control discrete On and Off IR commands are used by
installers when programming macro commands into universal remotes.
Using an On-only or Off-only command is more effective than a toggle
On/Off command when trying to ensure the satellite receiver is reliably
in one state or the other. To use discrete power commands, complete
the following:
1Program the DISH Network remote to the desired remote address
(see Changing the Remote and Receiver Address in the next
section).
2Hold the SAT mode button until all mode buttons light, then
release.
3Press POWER (not TV POWER).
4Press VOLUME UP for discrete power on, or VOLUME DOWN
for discrete power off.
5Press any other button when done to end this procedure.