Dish Network 7100/200 manual Programming the Remote Control, Programming for Television Operation

Programming the Remote Control

This section explains how to program your remote to control your television and VCR. This will allow you to adjust the volume, turn the television on and off, change channels, and control your VCR.

Programming for Television Operation

The remote control is already preprogrammed to control the DISHPlayer receiver. To program the remote to control your television, do the following:

1.Find the three-digit code for your TV manufacturer in the Televi- sions table on page 8. Use the first number listed if more than one set of numbers appears for your TV.

2.Set the TV/VCR SAT mode switch on the right side of the remote control to TV/VCR.

3.Press and hold the CODESET button on the left side of the remote control for six seconds.

4.Enter the appropriate three-digit code, which you found in step 1 for your television model.

5.Press ENTER.

6.Set the TV/VCR SAT mode switch back to SAT.

7.Verify that the code works by pressing the Volume button on the remote (see below).

8.For quick reference, write the number from step 1 down in the table on the inside of the back cover of this manual.

The remote control is now programmed to control your TV.

To verify that the remote control operates your TV

With your TV turned on, press the Volume + on the remote control. If the remote does not change the volume on your TV, repeat the steps above using a different code listed for your TV manufacturer.

Programming for VCR Operation

To program the remote to control your VCR, do the following:

1.Find the three-digit code for your VCR manufacturer in the VCRs table on page 9. Use the first number listed if more than one set of numbers appears for your VCR.

2.Set the TV/VCR SAT mode switch on the right side of the remote control to TV/VCR.

3.Press and hold the CODSET button on the left side of the remote for six seconds.

4.Enter the appropriate three-digit code, which you found in step 1,

28