Manuals / Dixon / Lawn and Garden / Lawn Mower

Dixon ZTR 5502 CARE AND MAINTENANCE - 5000 SERIES MODELS, avoid the sharp edge of the blade, Page

Models: ZTR 5601 ZTR 5502 ZTR 5422

1 72

Download 72 pages 43.75 Kb

Page 28

CUTTER BLADE MAINTENANCE:

CARE AND MAINTENANCE - 5000 SERIES MODELS

CUTTER BLADE MAINTENANCE:

NOTE: Observe proper blade position prior to removal.

1. Safely raise front of mower.

2.Hold or block blade from turning.

CAUTION	Wear heavy, thick gloves when holding onto cutter blade,
	avoid the sharp edge of the blade.

NOTE: Be sure blade is centered on pilot before tightening bolt to 60 ft. Ibs. torque.

Page 25

Image 28

Dixon ZTR 5502 CARE AND MAINTENANCE - 5000 SERIES MODELS, avoid the sharp edge of the blade, Cutter Blade Maintenance

Contents

Page IMPORTANT - READ CAREFULLY INDEX SeptemberThe most common causes of injury to the operator or bystander SAFETYTIP-OVER SAFETY SYMBOLS SAFETYFollow recommended safety precautions and safe operating practices serious injury or death GENERAL OPERATIONSAFETY SLOPE OPERATIONSAFETY CHILDRENSAFETY SERVICEDIXON LIMITED WARRANTY POLICY -- HYDRO-GEAR MODELS 3. Battery warranty Limited to 90 days from date of purchase6. The following items are noLcovered by this warranty policy b Routine maintenance or adjustmentsSPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE SPECIFICATIONSModel ZTR SPECIFICATIONS SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICEModel ZTR X 5 smooth profileSPECIFICATIONS Model ZTRSEAT ADJUSTMENT INSTRUCTIONS CONTROLS PageCONTROLS CAUTION Engage parking brake before starting enginePARKING BRAKE TO SET PARKING BRAKECONTROLS TO GO FORWARDTO GO BACKWARD TURNINGCONTROLS Protection of the electrical system is by 115 amp circuit breakerOPERATION INSTRUCTIONS BLADE DRIVE SWITCH TEST 5000 Series TESTING OF SAFETY INTERLOCK SYSTEMSOPERATION INSTRUCTIONS OPERATION INSTRUCTIONS 1 . Push choke control lever fully forwardAlways turn engine off when leaving mower 1. Move throttle control lever to 1/4 to 1/2 settingOPERATION INSTRUCTIONS OPERATION INSTRUCTIONS MOWING WITH A MULCHING ATTACHMENTMOWING WITH A GRASS CATCHER ATTACHMENT OPERATION INSTRUCTIONS6. Maintain Sharp Blades Throughout The Cutting Season Be sure that deflector is properly installed on the discharge chute OPERATION INSTRUCTIONSSIDE DISCHARGE OF THE CLIPPINGS 5. Maintain Sharp Blades Throughout The Cutting SeasonDECK ROLLERS OPERATION INSTRUCTIONSPage MAINTENANCE SCHEDULE CARE AND MAINTENANCE - 5000 SERIES MODELSBefore performing any maintenance, shut off engine, allow to cool CARE AND MAINTENANCE - 5000 SERIES MODELS CUTTER BLADE MAINTENANCEWear heavy, thick gloves when holding onto cutter blade avoid the sharp edge of the bladeCARE AND MAINTENANCE - 5000 SERIES MODELS BELT TENSIONPeriodically inspect both belt and idler systems ENGINE TO MOWER DECK BELTFUEL SHUT OFF VALVE CARE AND MAINTENANCE - 5000 SERIES MODELSLUBRICATION CARE AND MAINTENANCE - 5000 SERIES MODELS 5000 SERIES REAR WHEELSCARE AND MAINTENANCE - 5000 SERIES MODELS PLEASE DISPOSE OF USED OILS AT PROPER COLLECTION CENTERSPROTECT YOUR ENVIRONMENT PROTECT YOUR INVESTMENTCARE AND MAINTENANCE - 5000 SERIES MODELS MOWER DECK INSTALLATIONCARE AND MAINTENANCE - 5000 SERIES MODELS PageCARE AND MAINTENANCE - 5000 SERIES MODELS T-BOX TO HYDROSTAT BELT ADJUSTMENTCARE AND MAINTENANCE - 5000 SERIES MODELS PARKING BRAKE CABLE ADJUSTMENTCARE AND MAINTENANCE - 5000 SERIES MODELS Swing upper control levers out into the neutral slotsCARE AND MAINTENANCE - 5000 SERIES MODELS FORWARD TRAVEL SPEED ADJUSTMENTSDO NOT SPEED UP THE SLOW SIDE, AS OVER STROKING OF THE HYDROSTAT COULD RESULT IN DAMAGE TO THE UNITPROCEDURE FOR ELECTRIC CLUTCH ADJUSTMENT CARE AND MAINTENANCE - 5000 SERIES MODELSB. OHMS TEST CARE AND MAINTENANCE - 5000 SERIES MODELS HYDROSTATIC TRANSMISSION OIL AND FILTER SERVICECLEANING THE MOWER SERIAL NUMBERS WARRANTY PARTS/SERVICE CARE AND MAINTENANCE - 5000 SERIES MODELSWHEELS AND TIRES Model ZTR Models ZTR 5502 & ZTR ELECTRICAL SYSTEMS STANDARD SERVICE PARTS LIST MODEL ZTRMODEL ZTR MODEL ZTRKOHLER AIR AND OIL FILTER PART NUMBERS STANDARD SERVICE PARTS LISTKOHLER ANTI-ICING KIT TROUBLESHOOTING MOWER CUT QUALITYTROUBLESHOOTING DRIVE SYSTEMSITUATION CAUSESTROUBLESHOOTING Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page PURCHASED FROM Name Address OWNER INFORMATIONFAX 316 251 Page Page Page Page Page Dixon and ZTR are registered trademarks of Dixon Industries, Inc