Manuals / Dixon / Lawn and Garden / Lawn Mower

Dixon ZTR 5422 manual Controls, Protection of the electrical system is by 115 amp circuit breaker

Models: ZTR 5601 ZTR 5502 ZTR 5422

1 72

Download 72 pages 43.75 Kb

Page 18

Image 18

Protection of the electrical system is by (1)15 amp circuit breaker.

CONTROLS

BLADE DRIVE:

Located on control panel, on operator's right.

To engage the mower blades, lift switch up lightly and push forward.

To disengage blades, pull switch backward.

Switch is clearly marked "on and off".

CIRCUIT BREAKER:

Located on control panel, on operator's right.

Protection of the electrical system is by (1)15 amp circuit breaker.

If circuit breaker trips, push button to reset.

If this condition repeats, consult dealer for inspection and repair.

MOWER DECK CUT HEIGHT LIFT LEVER:

Located to the right and front of operator.

Controls the cutting height.

Seven positions of adjustment, Model ZTR 5422.

Eight positions of adjustment, Model ZTR 5502 &

Model ZTR 5601.

Move lever in and forward to lower.

Move lever in and back to raise.

NOTE: Always use high position for transport.

Page 15

Page 18

Image 18

Dixon ZTR 5422, ZTR 5502, ZTR 5601 manual Controls, Protection of the electrical system is by 115 amp circuit breaker

Contents

Page IMPORTANT - READ CAREFULLY INDEX SeptemberSAFETY The most common causes of injury to the operator or bystanderTIP-OVER SAFETY SAFETY SYMBOLSFollow recommended safety precautions and safe operating practices serious injury or death GENERAL OPERATIONSAFETY SLOPE OPERATIONSAFETY CHILDRENSAFETY SERVICE6. The following items are noLcovered by this warranty policy DIXON LIMITED WARRANTY POLICY -- HYDRO-GEAR MODELS3. Battery warranty Limited to 90 days from date of purchase b Routine maintenance or adjustmentsSPECIFICATIONS SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICEModel ZTR Model ZTR SPECIFICATIONSSPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE X 5 smooth profileSPECIFICATIONS Model ZTRSEAT ADJUSTMENT INSTRUCTIONS CONTROLS PagePARKING BRAKE CONTROLSCAUTION Engage parking brake before starting engine TO SET PARKING BRAKETO GO BACKWARD CONTROLSTO GO FORWARD TURNINGCONTROLS Protection of the electrical system is by 115 amp circuit breakerOPERATION INSTRUCTIONS TESTING OF SAFETY INTERLOCK SYSTEMS BLADE DRIVE SWITCH TEST 5000 SeriesOPERATION INSTRUCTIONS OPERATION INSTRUCTIONS 1 . Push choke control lever fully forward1. Move throttle control lever to 1/4 to 1/2 setting Always turn engine off when leaving mowerOPERATION INSTRUCTIONS OPERATION INSTRUCTIONS MOWING WITH A MULCHING ATTACHMENTOPERATION INSTRUCTIONS MOWING WITH A GRASS CATCHER ATTACHMENT6. Maintain Sharp Blades Throughout The Cutting Season SIDE DISCHARGE OF THE CLIPPINGS Be sure that deflector is properly installed on the discharge chuteOPERATION INSTRUCTIONS 5. Maintain Sharp Blades Throughout The Cutting SeasonOPERATION INSTRUCTIONS DECK ROLLERSPage CARE AND MAINTENANCE - 5000 SERIES MODELS MAINTENANCE SCHEDULEBefore performing any maintenance, shut off engine, allow to cool Wear heavy, thick gloves when holding onto cutter blade CARE AND MAINTENANCE - 5000 SERIES MODELSCUTTER BLADE MAINTENANCE avoid the sharp edge of the bladePeriodically inspect both belt and idler systems CARE AND MAINTENANCE - 5000 SERIES MODELSBELT TENSION ENGINE TO MOWER DECK BELTCARE AND MAINTENANCE - 5000 SERIES MODELS FUEL SHUT OFF VALVELUBRICATION CARE AND MAINTENANCE - 5000 SERIES MODELS 5000 SERIES REAR WHEELSPROTECT YOUR ENVIRONMENT CARE AND MAINTENANCE - 5000 SERIES MODELSPLEASE DISPOSE OF USED OILS AT PROPER COLLECTION CENTERS PROTECT YOUR INVESTMENTCARE AND MAINTENANCE - 5000 SERIES MODELS MOWER DECK INSTALLATIONCARE AND MAINTENANCE - 5000 SERIES MODELS PageCARE AND MAINTENANCE - 5000 SERIES MODELS T-BOX TO HYDROSTAT BELT ADJUSTMENTCARE AND MAINTENANCE - 5000 SERIES MODELS PARKING BRAKE CABLE ADJUSTMENTCARE AND MAINTENANCE - 5000 SERIES MODELS Swing upper control levers out into the neutral slotsDO NOT SPEED UP THE SLOW SIDE, AS OVER STROKING OF THE CARE AND MAINTENANCE - 5000 SERIES MODELSFORWARD TRAVEL SPEED ADJUSTMENTS HYDROSTAT COULD RESULT IN DAMAGE TO THE UNITCARE AND MAINTENANCE - 5000 SERIES MODELS PROCEDURE FOR ELECTRIC CLUTCH ADJUSTMENTB. OHMS TEST CARE AND MAINTENANCE - 5000 SERIES MODELS HYDROSTATIC TRANSMISSION OIL AND FILTER SERVICECARE AND MAINTENANCE - 5000 SERIES MODELS CLEANING THE MOWER SERIAL NUMBERS WARRANTY PARTS/SERVICEWHEELS AND TIRES Model ZTR Models ZTR 5502 & ZTR ELECTRICAL SYSTEMS MODEL ZTR STANDARD SERVICE PARTS LISTMODEL ZTR MODEL ZTRSTANDARD SERVICE PARTS LIST KOHLER AIR AND OIL FILTER PART NUMBERSKOHLER ANTI-ICING KIT TROUBLESHOOTING MOWER CUT QUALITYSITUATION TROUBLESHOOTINGDRIVE SYSTEM CAUSESTROUBLESHOOTING Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page OWNER INFORMATION PURCHASED FROM Name AddressFAX 316 251 Page Page Page Page Page Dixon and ZTR are registered trademarks of Dixon Industries, Inc