Manuals / Dixon / Lawn and Garden / Lawn Mower

Dixon ZTR 5601 CARE AND MAINTENANCE - 5000 SERIES MODELS, Belt Tension, Engine To Mower Deck Belt

Models: ZTR 5601 ZTR 5502 ZTR 5422

1 72

Download 72 pages 43.75 Kb

Page 29

Image 29

CARE AND MAINTENANCE - 5000 SERIES MODELS

BELT TENSION

ENGINE TO MOWER DECK BELT:
Models ZTR 5422 & ZTR 5502	P/N 61 1 1
Model ZTR 5601	P/N 6939

MOWER DECK SERPENTINE BELT:
Model ZTR 5422	P/N 6109
Model ZTR 5502	P/N 1300
Model ZTR 5601	P/N 6938

Refer to illustration for adjustment procedure.

NOTE: Belt deflection or movement should be approximately 1/4" when measured at mid-point between pulleys.

Periodically inspect both belt and idler systems.

Page 26

Page 29

Image 29

Dixon ZTR 5601 CARE AND MAINTENANCE - 5000 SERIES MODELS, Belt Tension, Periodically inspect both belt and idler systems

Contents

Page IMPORTANT - READ CAREFULLY September INDEXTIP-OVER SAFETYThe most common causes of injury to the operator or bystander Follow recommended safety precautions and safe operating practices SAFETYSAFETY SYMBOLS GENERAL OPERATION serious injury or deathSLOPE OPERATION SAFETYCHILDREN SAFETYSERVICE SAFETY3. Battery warranty Limited to 90 days from date of purchase DIXON LIMITED WARRANTY POLICY -- HYDRO-GEAR MODELS6. The following items are noLcovered by this warranty policy b Routine maintenance or adjustmentsModel ZTR SPECIFICATIONSSPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE SPECIFICATIONSModel ZTR X 5 smooth profileModel ZTR SPECIFICATIONSSEAT ADJUSTMENT INSTRUCTIONS Page CONTROLSCAUTION Engage parking brake before starting engine CONTROLSPARKING BRAKE TO SET PARKING BRAKETO GO FORWARD CONTROLSTO GO BACKWARD TURNINGProtection of the electrical system is by 115 amp circuit breaker CONTROLSOPERATION INSTRUCTIONS OPERATION INSTRUCTIONS TESTING OF SAFETY INTERLOCK SYSTEMSBLADE DRIVE SWITCH TEST 5000 Series 1 . Push choke control lever fully forward OPERATION INSTRUCTIONSOPERATION INSTRUCTIONS 1. Move throttle control lever to 1/4 to 1/2 settingAlways turn engine off when leaving mower MOWING WITH A MULCHING ATTACHMENT OPERATION INSTRUCTIONS6. Maintain Sharp Blades Throughout The Cutting Season OPERATION INSTRUCTIONSMOWING WITH A GRASS CATCHER ATTACHMENT OPERATION INSTRUCTIONS Be sure that deflector is properly installed on the discharge chuteSIDE DISCHARGE OF THE CLIPPINGS 5. Maintain Sharp Blades Throughout The Cutting SeasonPage OPERATION INSTRUCTIONSDECK ROLLERS Before performing any maintenance, shut off engine, allow to cool CARE AND MAINTENANCE - 5000 SERIES MODELSMAINTENANCE SCHEDULE CUTTER BLADE MAINTENANCE CARE AND MAINTENANCE - 5000 SERIES MODELSWear heavy, thick gloves when holding onto cutter blade avoid the sharp edge of the bladeBELT TENSION CARE AND MAINTENANCE - 5000 SERIES MODELSPeriodically inspect both belt and idler systems ENGINE TO MOWER DECK BELTLUBRICATION CARE AND MAINTENANCE - 5000 SERIES MODELSFUEL SHUT OFF VALVE 5000 SERIES REAR WHEELS CARE AND MAINTENANCE - 5000 SERIES MODELSPLEASE DISPOSE OF USED OILS AT PROPER COLLECTION CENTERS CARE AND MAINTENANCE - 5000 SERIES MODELSPROTECT YOUR ENVIRONMENT PROTECT YOUR INVESTMENTMOWER DECK INSTALLATION CARE AND MAINTENANCE - 5000 SERIES MODELSPage CARE AND MAINTENANCE - 5000 SERIES MODELST-BOX TO HYDROSTAT BELT ADJUSTMENT CARE AND MAINTENANCE - 5000 SERIES MODELSPARKING BRAKE CABLE ADJUSTMENT CARE AND MAINTENANCE - 5000 SERIES MODELSSwing upper control levers out into the neutral slots CARE AND MAINTENANCE - 5000 SERIES MODELSFORWARD TRAVEL SPEED ADJUSTMENTS CARE AND MAINTENANCE - 5000 SERIES MODELSDO NOT SPEED UP THE SLOW SIDE, AS OVER STROKING OF THE HYDROSTAT COULD RESULT IN DAMAGE TO THE UNITB. OHMS TEST CARE AND MAINTENANCE - 5000 SERIES MODELSPROCEDURE FOR ELECTRIC CLUTCH ADJUSTMENT HYDROSTATIC TRANSMISSION OIL AND FILTER SERVICE CARE AND MAINTENANCE - 5000 SERIES MODELSWHEELS AND TIRES Model ZTR Models ZTR 5502 & ZTR ELECTRICAL SYSTEMS CARE AND MAINTENANCE - 5000 SERIES MODELSCLEANING THE MOWER SERIAL NUMBERS WARRANTY PARTS/SERVICE MODEL ZTR STANDARD SERVICE PARTS LISTMODEL ZTR MODEL ZTRKOHLER ANTI-ICING KIT STANDARD SERVICE PARTS LISTKOHLER AIR AND OIL FILTER PART NUMBERS MOWER CUT QUALITY TROUBLESHOOTINGDRIVE SYSTEM TROUBLESHOOTINGSITUATION CAUSESTROUBLESHOOTING Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page FAX 316 251 OWNER INFORMATIONPURCHASED FROM Name Address Page Page Page Page Page Dixon and ZTR are registered trademarks of Dixon Industries, Inc

BELT TENSION

ENGINE TO MOWER DECK BELT:

MOWER DECK SERPENTINE BELT:

Periodically inspect both belt and idler systems.