Manuals / Dixon / Lawn and Garden / Lawn Mower

Dixon ZTR 5502, ZTR 5422, ZTR 5601 manual CARE AND MAINTENANCE - 5000 SERIES MODELS

Models: ZTR 5601 ZTR 5502 ZTR 5422

1 72

Download 72 pages 43.75 Kb

Page 37

Swing upper control levers out into the neutral slots.

CARE AND MAINTENANCE - 5000 SERIES MODELS

NEUTRALADJUSTMENT:

Swing upper control levers out into the neutral slots.

Raise upper body to the fully open position. Start engine

and disengage parking brake.

Caution should be used when releasing parking brake as mower may tend to creep or move prior to adjustment.

If adjustment is required, loosen lock nuts at each end of the control rods and back off the tension on each spring block.

Turn control rods in or out until neutral is obtained on each hydrostat.

Re-tighten lock nuts and tension bolts on spring blocks.

Page 34

Image 37

Dixon ZTR 5502, ZTR 5422 CARE AND MAINTENANCE - 5000 SERIES MODELS, Swing upper control levers out into the neutral slots

Contents

Page IMPORTANT - READ CAREFULLY September INDEXThe most common causes of injury to the operator or bystander SAFETYTIP-OVER SAFETY SYMBOLS SAFETYFollow recommended safety precautions and safe operating practices GENERAL OPERATION serious injury or deathSLOPE OPERATION SAFETYCHILDREN SAFETYSERVICE SAFETY3. Battery warranty Limited to 90 days from date of purchase DIXON LIMITED WARRANTY POLICY -- HYDRO-GEAR MODELS6. The following items are noLcovered by this warranty policy b Routine maintenance or adjustmentsSPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE SPECIFICATIONSModel ZTR SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE SPECIFICATIONSModel ZTR X 5 smooth profileModel ZTR SPECIFICATIONSSEAT ADJUSTMENT INSTRUCTIONS Page CONTROLSCAUTION Engage parking brake before starting engine CONTROLSPARKING BRAKE TO SET PARKING BRAKETO GO FORWARD CONTROLSTO GO BACKWARD TURNINGProtection of the electrical system is by 115 amp circuit breaker CONTROLSOPERATION INSTRUCTIONS BLADE DRIVE SWITCH TEST 5000 Series TESTING OF SAFETY INTERLOCK SYSTEMSOPERATION INSTRUCTIONS 1 . Push choke control lever fully forward OPERATION INSTRUCTIONSAlways turn engine off when leaving mower 1. Move throttle control lever to 1/4 to 1/2 settingOPERATION INSTRUCTIONS MOWING WITH A MULCHING ATTACHMENT OPERATION INSTRUCTIONSMOWING WITH A GRASS CATCHER ATTACHMENT OPERATION INSTRUCTIONS6. Maintain Sharp Blades Throughout The Cutting Season OPERATION INSTRUCTIONS Be sure that deflector is properly installed on the discharge chuteSIDE DISCHARGE OF THE CLIPPINGS 5. Maintain Sharp Blades Throughout The Cutting SeasonDECK ROLLERS OPERATION INSTRUCTIONSPage MAINTENANCE SCHEDULE CARE AND MAINTENANCE - 5000 SERIES MODELSBefore performing any maintenance, shut off engine, allow to cool CUTTER BLADE MAINTENANCE CARE AND MAINTENANCE - 5000 SERIES MODELSWear heavy, thick gloves when holding onto cutter blade avoid the sharp edge of the bladeBELT TENSION CARE AND MAINTENANCE - 5000 SERIES MODELSPeriodically inspect both belt and idler systems ENGINE TO MOWER DECK BELTFUEL SHUT OFF VALVE CARE AND MAINTENANCE - 5000 SERIES MODELSLUBRICATION 5000 SERIES REAR WHEELS CARE AND MAINTENANCE - 5000 SERIES MODELSPLEASE DISPOSE OF USED OILS AT PROPER COLLECTION CENTERS CARE AND MAINTENANCE - 5000 SERIES MODELSPROTECT YOUR ENVIRONMENT PROTECT YOUR INVESTMENTMOWER DECK INSTALLATION CARE AND MAINTENANCE - 5000 SERIES MODELSPage CARE AND MAINTENANCE - 5000 SERIES MODELST-BOX TO HYDROSTAT BELT ADJUSTMENT CARE AND MAINTENANCE - 5000 SERIES MODELSPARKING BRAKE CABLE ADJUSTMENT CARE AND MAINTENANCE - 5000 SERIES MODELSSwing upper control levers out into the neutral slots CARE AND MAINTENANCE - 5000 SERIES MODELSFORWARD TRAVEL SPEED ADJUSTMENTS CARE AND MAINTENANCE - 5000 SERIES MODELSDO NOT SPEED UP THE SLOW SIDE, AS OVER STROKING OF THE HYDROSTAT COULD RESULT IN DAMAGE TO THE UNITPROCEDURE FOR ELECTRIC CLUTCH ADJUSTMENT CARE AND MAINTENANCE - 5000 SERIES MODELSB. OHMS TEST HYDROSTATIC TRANSMISSION OIL AND FILTER SERVICE CARE AND MAINTENANCE - 5000 SERIES MODELSCLEANING THE MOWER SERIAL NUMBERS WARRANTY PARTS/SERVICE CARE AND MAINTENANCE - 5000 SERIES MODELSWHEELS AND TIRES Model ZTR Models ZTR 5502 & ZTR ELECTRICAL SYSTEMS MODEL ZTR STANDARD SERVICE PARTS LISTMODEL ZTR MODEL ZTRKOHLER AIR AND OIL FILTER PART NUMBERS STANDARD SERVICE PARTS LISTKOHLER ANTI-ICING KIT MOWER CUT QUALITY TROUBLESHOOTINGDRIVE SYSTEM TROUBLESHOOTINGSITUATION CAUSESTROUBLESHOOTING Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page PURCHASED FROM Name Address OWNER INFORMATIONFAX 316 251 Page Page Page Page Page Dixon and ZTR are registered trademarks of Dixon Industries, Inc