CARE AND MAINTENANCE - 5000 SERIES MODELS
PROCEDURE FOR ELECTRIC CLUTCH ADJUSTMENT
Electric clutches require periodic Air Gap adjustments to extend the life of the clutch. Listed below is both an Air Gap adjustment procedure and an Ohms test to check for a faulty coil within the clutch. No replacement parts are available to repair a faulty assembly. The entire clutch must be replaced.
A. AIR GAP ADJUSTMENT
1.Remove the clutch from the engine. This is recommended because it is easier to verify the gap.
2.Locate the three rivet joints which fasten the leaf springs
v, to the armature, (figure 1)
3.Rotate the pulley until these rivet joints are located midway along the edge of the triangular field adapter, (figure 1)
4.Locate the three holes in the brake plate, one near each adjustment nut. (figure 2)
5.Insert a .012 inch feeler gauge into one of the three windows. Be careful to position the feeler gauge between the rotor and armature faces, (figure 3)
6.Tighten the adjusting nut adjacent to the window with the feeler gauge inserted until the
gauge fits snugly between the rotor and armature. The gap should not be so tight that the feeler gauge cannot be reinserted after removal.
7.Repeat Steps 5 and 6 at the other two windows.
8.
.012 inch air gap.
9.Reinstall the clutch to the engine. Be sure to torque the mounting bolt back to 50 ft. Ibs.
B.OHMS TEST:
1.Disconnect clutch from mower wiring harness which is located on the right side of the mower frame.
2.Set the
3.The reading you receive should be between 2.4 to 2.9 OHMS.
4.If the resistance is outside this range the clutch coil is faulty.
5.If the clutch coil is faulty, the clutch must be replaced.
Page 36
