Dolmar MS-22C instruction manual Mounting of Nylon Cutter Head

MOUNTING OF NYLON CUTTER HEAD

Turn the machine upside down, and you can replace the nylon cutting head.

–Insert the hex wrench through the hole in the gear case and rotate the receiver washer (3) until it is locked with the hex wrench.

–Loosen the nut (1) (left-hand thread) with the socket wrench and remove the nut (1), and clamp washer (2).

NOTE:The clamp washer (2), and nut (1) are not necessary for mounting the nylon cutting head. The nylon head should go on top of the receiver washer (3).

–Screw the nylon cutting head onto the shaft.

Tighten

Loosen

Hex wrench

–Make sure that the blade is the left way up.

Rotation

10