FUELS/REFUELING

Handling fuel

Utmost care is required when handling fuel. Fuel may contain substances similar to solvents. Refuel either in a well ventilated room or outdoors. Do not inhale fuel vapors, avoid any contact of fuel or oil with your skin.

Mineral oil products degrease your skin. If your skin comes in contact with these substances repeatedly and for an extended period of time, it will desiccate. Various skin diseases may result. In addition, allergic reactions may occur. Eyes can be irritated by contact with oil. If oil comes into your eyes, immediately wash them with clear water. If your eyes are still irritated, see a doctor immediately.

Fuel and oil mixture

Inspect the fuel tank and fill with clean, fresh fuel of the proper mixture to assure the longer life of the tool.

Use the following mixed gas.

Gasoline : DOLMAR genuine two-stroke engine oil = 50 : 1 or

Gasoline : Other Maker’s Two-stroke engine oil = 25:1

FOR CALIFORNIA REGULATION:

THIS EQUIPMENT IS CERTIFIED TO OPERATE ON GASOLINE + TWO STROKE OIL

When mixing gasoline with two-stroke engine oil. use only unleaded gasoline which contains no ethanol, or methanol (type of alcohol).

This will help to avoid possible damage to engine fuel lines and other engine parts.

Do not mix gasoline and oil directly in the fuel tank.

IMPORTANT: Failure to follow proper fuel mix instructions may cause damage to the engine.

CAUTION: 1. When preparing fuel mixture, mix only the amount needed for the job you aref to do.

Do not use fuel mixture that has been stored longer than two months.

Fuel mixture stored longer than two months will cause hard starting and poor performance.

If fuel mixture has been stored longer than this time, if should be removed and filled with a fresh mixture.

2.Never fill the fuel tank to the very top.

3.Never add the fuel to the tank in a closed unventilatede area.

4.Do not add fuel to this unit close to an open fire or sparks.

5.Be sure to wipe off spilled fuel before attempting to start the engine.

6.Do not attempt to refuel a hot engine.

Observe the Safety Instructions on page 4 !

Check points before operation

1.Check for loose bolts, nuts and fittings.

2.Check the air cleaner for dirt. Clean the air filter of all dirt, etc. before operation

3.Check to be sure that protector is securely in place.

Refueling

The engine must be switched off.

Thoroughly clean the area around the fuel filler cap (2), to prevent dirt from getting into the fuel tank (1).

Unscrew the fuel filler cap (2) and fill the tank with fuel.

Tightly screw on the fuel filler cap (2).

Clean screw fuel filler cap (2) and tank after refueling.

Storage of Fuel

Fuel cannot be stored for an unlimited period of time.

Purchase only the quantity required for a 4 week operating period. Only use approved fuel storage containers.

11

Page 11
Image 11
Dolmar MS-22C Fuels/Refueling, Handling fuel, Fuel and oil mixture, Check points before operation, Storage of Fuel