Dolmar MS-22C Assembly Of Engine And Shaft, Mounting Of Handle, For machine with Loop handle

ASSEMBLY OF ENGINE AND SHAFT

CAUTION: Before doing any work on the string trimmer, always switch off the engine and pull the spark plug connector off the spark plug. Always wear protective gloves.

CAUTION: Start the string trimmer only after having assembled it completely.

–Insert the drive shaft into the holder case (Fig).

Note: Always insert the drive shaft into the Clutch case fully (approx. 58 mm). If the inner shaft resists full insertion of the drive shaft, try to insert it again after slightly rotating the drive shaft or the support washer on the gear case to match the inner shaft to the hole inside the holder case.

–After making sure that the drive shaft is installed fully and properly, tighten the socket head bolt (M5 x 14) and socket head bolt (M5 x 25) to secure the drive shaft.

–Inset control cable (1) through adjusting cable (2) and fit nipple of control cable into swivel (3) of carburetor.

Connect the switch cords to the two cords from the engine by inserting one into the other.

–Fix the cord connector by clamp.

Clutch case

Socket	Socket	Drive shaft
head bolt	head bolt
(M5 x 14)	(M5 x 25)

Connectors

MOUNTING OF HANDLE

CAUTION: Before doing any work on the string trimmer, always switch off the engine and pull the spark plug connector off the spark plug. Always wear protective gloves.

CAUTION: Start the string trimmer only after having assembled it completely.

For machine with Loop handle

–Do not adjust position of the loop handle too close to the control grip

–The standard position of the handle is 200mm to 250mm from the hanger.

to engine

8