CORRECT HANDLING OF MACHINE

Attachment of shoulder strap

Adjust the strap length so that the cutter blade will be kept parallel with the ground.

Detachment

In an emergency, push the notches (1) at both sides, and you can detach the machine from you.

Be extremely careful to maintain control of the machine at this time. Do not allow the machine to be deflected toward you or anyone in the work vicinity.

WARNING: Failure to maintain complete control of the machine at all could result in serious bodily injury or DEATH.

(1)

Hanger

PUTTING INTO OPERATION

Observe the applicable accident prevention regulations.

Starting

Move at least 3m away from the place of refuelling. Place the string trimmer on a clean piece of ground taking care that the nylon cutting head does not come into contact with the ground or any other objects.

Cold start

For machine with Loop Handle

 

– Push the I-O switch (1) in the direction shown by the arrow.

(1)

First place the machine on the ground.

Give a gentle push on the primer pump (1) repeatedly (7-10 times) until fuel comes into the primer pump.

Push the choke button (2) to the position " "

– Firmly hold the clutch case by your left hand, as illustrated.

(2)

(1)

 

Slowly pull the starter grip until resistance is felt and continue with a smart pull.

– Do not pull out the starter rope to its full extent and do not allow the starter handle to be retracted without control, but ensure that it is retracted slowly.

– Repeat the starting operation until initial ignitions are heard.

When the engine starts, please open the throttle lever a little. The choke button being automatic, it returns to original position " ".

Run the engine for approximately one minute at a moderate speed before applying full throttle.

12

Page 12
Image 12
Dolmar MS-22C instruction manual Correct Handling of Machine, Putting Into Operation