Replacing filter
The filter needs to be replaced:
-At least every 6 months.
-When filter lamp is lit on the control panel.
-When the flow has decreased to about half the normal amount.
-If the water from the water purifier has an unpleasant taste.
Filter replacement when the filter lamp is lit:
1. Empty the water purifier, see section “Draining”.
2.Fold up the handle and lift out the old filter in accor- dance with the arrow in figure F. Take care not to drip any water on the water purifier.
3.If the filter housing is dirty, clean the inside of the fil- ter housing carefully with a dishwashing brush.
Clean with a dishwashing brush and water only. Do not damage the tube in the centre of the filter housing.
4.Install a new filter.
5.Check that the seal is in place in the lid. Refit filter housing lid by pressing and turning in the opposite direction to the arrows.
6.Refit the top cover and switch on the current to the water purifier using the safety switch in the central electrical unit.
7.Open the shut off valve on the inlet hose and start the purifier by pressing the ON/OFF button.
8.Turn off the filter lamp by pressing in the ON/OFF button, see fig. G, and keeping it pressed until the fil- ter light goes out (approx. 5 seconds).
9.Open the
Filter replacement before indication and when the filter lamp is flashing:
1.Replace filter in accordance with point
2.Switch off the water purifier with the ON/OFF button.
3.Press in the ON/OFF button and keep it pressed. After 3 seconds the filter lamp comes on.
4.Release the button when the filter lamp goes out.
5.Start the water purifier with the ON/OFF button.
MAINTENANCE
F
G
9
