Draytek 2910 manual Ipcp

	Packet Trigger -The backup line is not on until a packet from a
	local host triggers the router to establish a connection.
WAN Connection	Such function allows you to verify whether network connection
Detection	is alive or not through ARP Detect or Ping Detect.
	Mode – Choose ARP Detect or Ping Detect for the system to
	execute for WAN detection.
	Ping IP – If you choose Ping Detect as detection mode, you have
	to type IP address in this field for pinging.
	TTL (Time to Live) – Displays value for your reference. TTL
	value is set by telnet command.
PPP/MP Setup	PPP Authentication – Select PAP only or PAP or CHAP for
	PPP.
	Idle Timeout – Set the timeout for breaking down the Internet
	after passing through the time without any action. This setting is
	active only when the Active on demand option for Active Mode is
	selected in WAN>> General Setup page.
IP Address	Usually ISP dynamically assigns IP address to you each time you
Assignment Method	connect to it and request. In some case, your ISP provides service
(IPCP)	to always assign you the same IP address whenever you request.
	In this case, you can fill in this IP address in the Fixed IP field.
	Please contact your ISP before you want to use this function.
	WAN IP Alias - If you have multiple public IP addresses and
	would like to utilize them on the WAN interface, please use WAN
	IP Alias. You can set up to 8 public IP addresses other than the
	current one you are using. Notice that this setting is available for
	WAN1 only.

Fixed IP – Click Yes to use this function and type in a fixed IP address in the box of Fixed IP Address.

Default MAC Address – You can use Default MAC Address or specify another MAC address by typing on the boxes of MAC Address for the router.

Vigor2910 Series User’s Guide 33