Draytek 2910 manual AP Discovery

Security	There are three types for security, Disable, WEP and
	Pre-shared key. The setting you choose here will make the
	following WEP or Pre-shared key field valid or not. Choose
	one of the types for the router.
WEP	Check this box to use the same key set in Security Settings
	page. If you did not set any key in Security Settings page,
	this check box will be dimmed.
Settings	Encryption Mode - If you checked the box of Use the same
	WEP key …, you do not need to choose 64-bit or 128-bit as
	the Encryption Mode. If you do not check that box, you can
	set the WEP key now in this page.
	Key Index - Choose the key that you want to use after
	selecting the proper encryption mode.
	Key - Type the content for the key.
Pre-shared Key	Type 8 ~ 63 ASCII characters or 64 hexadecimal digits
	leading by “0x”.
Bridge	If you choose Bridge as the connecting mode, please type in
	the peer MAC address in these fields. Six peer MAC
	addresses are allowed to be entered in this page at one time.
	Yet please disable the unused link to get better performance.
	If you want to invoke the peer MAC address, remember to
	check Enable box in the front of the MAC address after
	typing.
Repeater	If you choose Repeater as the connecting mode, please type in
	the peer MAC address in these fields. Two peer MAC
	addresses are allowed to be entered in this page at one time.
	Similarly, if you want to invoke the peer MAC address,
	remember to check Enable box in the front of the MAC
	address after typing.
Access Point Function	Click Enable to make this router serving as an access point;
	click Disable to cancel this function.
Status	It allows user to send “hello” message to peers. Yet, it is valid
	only when the peer also supports this function.

3.12.6 AP Discovery

Vigor router can scan all regulatory channels and find working APs in the neighborhood. Based on the scanning result, users will know which channel is clean for usage. Also, it can be used to facilitate finding an AP for a WDS link. Notice that during the scanning process (about 5 seconds), no client is allowed to connect to Vigor.

This page is used to scan the existence of the APs on the wireless LAN. Yet, only the AP which is in the same channel of this router can be found. Please click Scan to discover all the connected APs.

Vigor2910 Series User’s Guide 161