XDMA6540 OPERATION
Bluetooth® Operation
Pairing a Device
PreparationPairing a New Device
Pairing Additional Devices
Before you can use a Bluetooth device, it must be paired and connected. Make sure that Bluetooth is activated on your device before you begin the pairing process.
The XDMA6540 broadcasts the pairing signal constantly when no devices are currently connected. Complete the pairing sequence from your Bluetooth device. Refer to the owner's manual for your device for more details.
The device name is "DUAL BT"
The Bluetooth passcode "1234"
Note: The XDMA6540 can be in any mode of operation when pairing is performed.
If a device is currently connected, press and hold 
to disconnect the current device before a new device can be paired. Then begin the pairing sequence from the new Bluetooth device.
(Re)Connecting a Paired Device
Most Bluetooth devices support the
•If your most recently connected Bluetooth device becomes disconnected or does not reconnect, press 
from Bluetooth mode to reconnect your mobile device.
•To connect a previously paired device that was not recently connected:
1)If applicable, press and hold 
to disconnect any connected mobile devices.
2)From Bluetooth mode, press SELECT. "Paired Devices" will appear on the LCD.
3)Turn the volume knob to cycle through the list of devices.
4)Press SELECT or 
to connect to the desired device. It must be in range to connect.
Note: If the Auto Connect setup menu setting is set to OFF, you must press 
to connect you device after pairing, and each time the XDMA6540 is
Disconnecting a Device
Press and hold 
for 3 seconds to disconnect a connected device. The device will remain paired and appear in the PAIRED DEVICES menu, but not be connected.
28
