Dukane 8055 Signal Searching, Selecting The Aspect Ratio, Temporarily Blanking The Screen

Operating (continued)

Signal Searching

VIDEO RGB	SEARCH
ASPECT	AUTO	BLANK
MAGNIFY	PAGE UP	VOLUME
HOME
ON
END	PAGE DOWN	MUTE
OFF

FREEZEKEYSTONE

1	Press the SEARCH button.
	Cycle through input signals, displaying the images of retrieved signals. If
	no signal is found, returns to the signal that was selected before the search
	was begun.
	RGB	VIDEO	S-VIDEO
			SEARCH
		COMPONENT VIDEO

NOTE • May not function properly with some input signals.

• The signal searching function takes about 10 seconds to display an image.

Selecting The Aspect Ratio

VIDEO RGB	SEARCH
ASPECT	AUTO	BLANK
MAGNIFY	PAGE UP	VOLUME
HOME
ON
END	PAGE DOWN	MUTE
OFF
FREEZE		KEYSTONE
POSITION		MENU
ENTER
ESC		RESET

1 Press the ASPECT button.
RGB input	ASPECT

4:3 16:9 15:9 32:15

•At a RGB input, selecting an aspect ratio may display the message “SYNC IS OUT OF RANGE”. In this case, please select one of other aspect ratios.

VIDEO, S-VIDEO, COMPONENT VIDEO input

4:3 16:9 WIDEZOOM

•At a COMPONENT VIDEO input of 16:9 Hi-Vision of 1125i (1035i/1080i)/750p, only 16:9 can be selected.

•When the 4:3 is selected under the SCREEN TYPE item of the OPTION menu. WIDE and ZOOM cannot be selected.

Temporarily Blanking The Screen

VIDEO RGB	SEARCH
ASPECT	AUTO	BLANK
MAGNIFY	PAGE UP	VOLUME
HOME

ON

1	Press the BLANK button.
	The input signal screen is shut off, and a blank screen appears. You can
	set the blank screen using the menu (from the SCREEN menu, BLANK
	select BLANK).
	Press the BLANK button again to remove the blank screen,
	and return to the input signal screen.

NOTE • The temporarily blanking function will automatically finish if either the STANDBY/ON, SEARCH, RGB, VIDEO, FREEZE, AUTO, VOLUME, MUTE, POSITION or MENU button of remote control is pressed, or if a button of projector is pressed, or if there is a change in the input signal’s state.

21