Part names
Part names
Projector
Zoom knob ( 18)
Focus ring ( 18)
Vent ( 6)
Lens ( 16)
Lamp cover ( 39) (Lamp unit is inside.)
Control buttons ( 5) (See the following page.)
Ports (See below.)
AC inlet ( 13)
Power switch ( 16)
Remote sensor ( 15)
| Elevator button ( 8) |
Elevator foot ( 8) | |
| Filter cover ( 9,40) |
| (Air fi lter and intake vent |
| are inside.) |
Speaker
Elevator button ( 8)
Elevator foot ( 8)
Vent ( 6)
Restart switch (*) ( 46)
RGB IN1 port ( 11 )
|
|
| RGB IN1 | RGB IN2 |
|
|
COMPONENT |
|
|
| AUDIO | RGB IN2 port ( 11 ) | |
|
|
|
|
| ||
VIDEO ports ( 12) | COMPONENT VIDEO |
|
|
| ||
Y | RGB OUT | CONTROL |
| |||
CB/PB | CR/PR | CB/PB | Y |
|
| AUDIO |
CR/PR |
|
|
|
|
|
|
| VIDEO |
|
|
| ||
AUDIO 2 L/R port ( 12) |
|
|
| CONTROL port ( 11 ) | ||
VIDEO port ( 12) |
|
| Ports | |||
|
|
| RGB OUT port ( 11 ) |
NOTE (*) About Restart switch: This projector is controlled by an internal microprocessor. Under certain exceptional circumstances, the projector may not operate correctly and the microprocessor will need to be reset. In such a case, please push the Restart switch by using a cocktail stick or similar, and before turning on again, make the projector cool down at least 10 minutes without operating. Only push the Restart switch in these exceptional instances.
4