Dukane 8915 user manual Option Menu, ONE Touch, Auto Search, Auto OFF

Multifunctional settings

OPTION Menu

With the OPTION menu, items shown in the table below can be performed.

Select an item using the cursor buttons ▲/▼ on the projector or remote control, and press the cursor button ► on the projector or remote control, or the ENTER button on the remote control to progress, except for the items LAMP TIME and FILTER TIME. Then perform it referring to the following table.

MENU [RGB]	:SELECT
PICTURE	ONETOUCH
IMAGE	AUTO SEARCH  TURN OFF
VIDEO Qlty.  AUTO OFF      0
INPUT	LAMP TIME     0
SETUP	FILTER TIME   0
SCREEN	SERVICE
OPTION
NETWORK
EASY MENU

Item

Description

	Using the buttons ▲/▼ turns on/off the automatic keystone
	correction function.
	TURN ON  TURN OFF
	You can automatically correct vertical keystone distortion
	corresponding to the angle (forward/backward tilt) at which the unit
ONE TOUCH	is set up. This function works with ONE TOUCH operation.
	• If the projection screen is inclined, or if the projector is angled
	downwards, it may not be possible to make the correct adjustment
	when V: INVERT or H&V: INVERT is selected under the MIRROR
	item of the SETUP menu.
	• When the zoom adjustment is set to the TELE side, automatic
	correction may be excessive. The automatic correction function
	should be used with zoom set to WIDE whenever possible.
	Using the buttons ▲/▼ turns on/off the automatic signal search
	function.
	TURN ON  TURN OFF
	This function works with INPUT, RGB, and VIDEO buttons.
AUTO SEARCH	When the TURN ON is selected, detecting no signal automatically
	cycles through input ports in order of following. The search is
	started from the current port. Then when an input is found, the
	projector will stop searching and display the image.
	RGB IN1  RGB IN2  DVI-D  COMPONENT VIDEO  S-VIDEO  VIDEO
	Using the buttons ▲/▼ adjusts the time to count down to
	automatically turn the projector off.
	Long (max. 99 minutes)  Short (min. 0 minute = DISABLE)
	AUTO OFF	AUTO OFF
	ENABLE	DISABLE
AUTO OFF	1	0
	When the time is set to 0, the projector is not turned off automatically.
	When the time is set to 1 to 99, and when the passed time with
	a no-signal or an unsuitable signal reaches at the set time, the
	projector lamp will go off and the power indicator begins blinking.
	Please refer to the section “Turning off the power” (16).

38