Dynacord MP7, ENTERTAINMENT SYSTEM owner manual Peak Led, EFFECT RETURN FX1 / FX2, EFFECT 1/2

EFFECT 1/2

26. PEAK LED

These indicators signal if the input stages of the internal FX-units are driven into clipping. To achieve an adequate S/N-ratio, please adjust the FX units’ input level as follows.

Note on how to adjust the FX input signal:

1. Establish a “dry” mix - without effect settings - according to the previous descriptions.

2. Set the FX-return control (27) of the corresponding effect channel to its center position.

3. Use the UP/DOWN-buttons to select the desired FX-program preset.

4. Press the FX ON-switch.

5. Play the sound source of the desired input channel and adjust the desired amount of the FX-signal, using the FX-controls of the input channel until the resulting effect mix meets your requirements. Repeat this procedure for all input channels that you would like to include in the effect mix.

6. Please make sure that the PEAK LED only lights frequently at highly dynamic signal peaks.

7. Now, using the FX-return controls lets you alter the percentage of the effect signal in the main mix.

It is good advice to keep an eye on the peak indicators when operating your MP7 to be able to quickly interact when the signal levels exceed the normal range and enter clipping.

27. EFFECT RETURN FX1 / FX2

The setting of these stereo controls determines the amount of the effect signal getting added to the main mix.

34