Dynacord ENTERTAINMENT SYSTEM T R A N Sition / Phones, 28. X/Y LED, Assignable Transition, Lamp

T R A N SITION / PHONES

28. X/Y LED

These LED’s indicate whether an input channel has been assigned to either side of the TRANSITION FADER (29). When these LED’s are dimmed, the transition function has not been activated for either input channel and the TRANSI- TION FADER is inactive.

29. ASSIGNABLE TRANSITION

This assignable fader allows comfortably cross-fading be- tween the audio signals of two selected input channels. Please refer to the paragraph TRANSITION SECTION in the chapter INPUT STEREO.

30. PHONES

This control lets you adjust the headphones’ volume.

Caution: Depending on the type of headphones connec- ted to the phones jack, the MP7 is capable of producing very high output levels via the phones output. Therefore, make sure to turn the control all the way to the left (minimum setting) before connecting the headphones. Be aware of the fact that listening to loud sound pressure levels over a longer period of time leads to hearing-da- mage!

31. PHONES MIX

This fader lets you cross-fade the PFL (audio signal sum of all channels with engaged PFL-function) and PGM (the actual master signal) audio signals via headphones.

The fader lets you pre-listen the function of the TRANSITION FADER via headphones.

32. PHONES

STEREO phones jack for the connection of headphones with an impedance of 32 - 600 ohms. Two phones connectors are available: one on the controls panel and one on the mixer’s front panel.

33. LAMP

XLR-socket for connecting a gooseneck litlite (12VDC / 2.4W max.). Please be sure to painstakingly mind the specificati- ons on the power consumption and pin-assignment of the used lamp. Overload or short-circuit can result in serious damage or failure of the output. If possible, only use the gooseneck litlite (112700), which is available from the DY- NACORD accessory assortment. If in doubt, please consult your local dealer.

35