Eagle Electronics 250 DS, 250 DF manual Assemble transducer and bracket

Metal

Nut washer

Rubber	Metal washer
washers
	Bolt

Assemble transducer and bracket.

4.Drilling mounting holes. Hold the transducer and bracket assembly against the transom. The transducer should be roughly parallel to the ground. The transducer's centerline should be in line with the bottom of the hull. Don't let the bracket extend below the hull!

Mark the center of each slot for the mounting screw pilot holes. You will drill one hole in the center of each slot.

Drill the holes using the #29 bit (for the #10 screws).

Transom

Transom

Position transducer mount on transom and mark mounting holes.

Side view (left) and shown from above (right).

5.Attaching transducer to transom. Remove the transducer from the bracket and re-assemble it with the cable passing through the bracket over the bolt as shown in the following figures.

13