Eagle Electronics 640C, 640cDF manual Hide GPS Features, Initialize GPS

tion begins. Press EXIT to clear the alarm.) When navigation starts, press ↑ to increase speed to the desired setting.

4.Press EXIT to turn off the steering and speed boxes. The unit will now automatically steer along the trail or route. When you arrive at your destination, cancel navigation.

Tip:

You can pick any spot on the map to begin a simulation by using the Initialize GPS command. It allows you to move the position ar- row to any location on the map. The command is detailed below.

Hide GPS Features

If there is no GPS antenna/receiver module attached to this unit, you can turn off its GPS features via the Hide GPS Features command. That will hide all GPS pages and menus.

To hide GPS features:

Press MENUMENU↓ to SYSTEM SETUPENT↓ to HIDE GPS FEATURESENT. The GPS menus and pages are now hidden.

To restore GPS Features, press MENUMENU↓ to SHOW GPS FEA- TURESENT. The GPS menus and pages are now accessible.

Initialize GPS

In simulator mode, the Initialize GPS command makes the unit operate as if it is sitting someplace other than its actual location. So you and your unit could be located in Kansas City, but practice navigating in the ocean off Islamorada, Florida.

NOTE:

Remember: if you want to run a simulation in a place other than your current location, you first must Initialize the GPS, then turn on the GPS Simulator.

1.Press MENUMENU↓ to GPS SETUPENTENT.

2.A message appears, telling you to move the cursor near the desired location and press ENT. When the message automatically clears, follow the message instructions.

3.In a moment, your present position marker arrow appears on the map in the location you selected with the cursor. The unit will consider that spot as its last known position until changed by either a live satel- lite lock-on or a new simulator location.

140