Appendix D - Wiring for EAGLE GPS models
Wiring for Eagle GPS models with
FishElite 480 | FishElite 500c |
FishElite 502c iGPS | FishElite 640c |
FishElite 642c iGPS | SeaCharter 500c DF |
SeaCharter 502c DF iGPS | SeaCharter 640c DF |
SeaCharter 642c DF iGPS | IntelliMap 480 |
IntelliMap 500c | IntelliMap 502c iGPS |
IntelliMap 640c | IntelliMap 642c iGPS |
Cuda 250 S/Map |
|
1.Remove diode and resistor (installed at end of cable) – refer to next page for instructions
2.Connect wires as follows:
| Eagle GPS Unit |
|
|
Yellow (NMEA IN +) | Yellow (NMEA OUT) |
|
|
Green (NMEA IN | Drain – Bare Stranded (Ground) |
|
|
3.Configure the COM port on the connected EAGLE GPS unit. Refer to the documentation supplied with your EAGLE GPS model.
Wiring to Eagle GPS model with PC21X,
SeaCharter 480DF
1. Connect wires as follows:
Eagle GPS Unit | |
|
|
Yellow (NMEA IN +) | Yellow (NMEA OUT) |
|
|
Green (NMEA IN | Drain – Bare Stranded (Ground) |
|
|
2.Configure the COM port on the connected EAGLE GPS unit. Refer to the documentation supplied with your EAGLE GPS model.
52 | EAGLE - |