Eagle Electronics EVR-150 manual Ensure each connection is secure and weather proof

Procedure to remove the resistor and diode from NDC-4, 119-31, Adapter Cable:

You will notice near the end of the cable an adapter segment protected with black heat-shrink.

To connect the EAGLE GPS unit to the EVR-150 radio, you must first remove the adapter segment of the cable as shown in the following figures.

Remove the adapter segment at the end of your data cable as shown at left. Snip off the end of the cable protected by the black heat-shrink. At right, we have used clear heat-shrink for clarity, so you can see the diode and resistor protected within. Remove this portion of the cable.

After you've removed the adapter segment, use wire pliers to expose the ends of the five

remaining wires in the cable. Cut off the black, blue and white wires, then seal their ends with heatshrink.

Make the wire connections to the EVR-150 GPS/COM cable as follows:

•Strip about 1/4-inch (6.35 mm) of insulation from the Yellow wire and connect to the

Yellow wire on the EVR-150 GPS/COM cable.

•Connect the Bare Stranded Drain wire to the Green wire on the EVR-150 GPS/COM cable.

EAGLE GPS unit NDC-4, 119-31, Adapter Cable

EVR-150

GPS/COM Cable

Ensure each connection is secure and weather proof.

EAGLE - EVR-150 Installation and Operation Instructions 53