My safely remove hardware icon is gone

(i.e. shows up as usable drive in My Computer). It may take up to 45 minutes to format a 500 GB or larger drive.

3. My “safely remove hardware” icon is gone

Caution: To prevent file corruption, please always click on the “safely remove hardware” icon in the taskbar’s notification area before unplugging external USB drives.

Re-register DLL Sometimes the “safely remove hardware” icon in the taskbar disappears. To re-register and re-activate the “safely remove hardware” window, please click on Start > click on Run > type in “RunDll32.exe shell32.dll,Control_RunDLL hotplug.dll” and hit Enter. Now you can click on the device you want to stop.

4. Error deleting file or folder

Drive busy This is usually caused by programs that are still accessing the drive and its contents. Common causes are open files such as Word document or open Explorer showing the directory content of the drive. Close them all and try again. File handles If you are still unable to delete files or folder, there are third party software that “unlocks” operating system file handles to let you delete “locked” files and folders. We recommend "Unlocker 1.8.7".

5. HI-speed device is plugged into a LO-speed USB port

Cabling system Make sure you are using certified HI-speed USB 2.0 cable, included with all Eagle Tech external hard drives and external drive enclosures, for improved data signal integrity. Low quality USB cables may not be properly shielded and may lose data during high speed transfers or at longer lengths.

Service Pack Certain USB 2.0 host controllers may need Service Packs to operate properly. Windows XP added support for USB 2.0 in Service Pack 2, Windows 2000 added support for USB 2.0 in Service Pack 3 and improved the support in Service Pack 4. Please download the latest service packs from Microsoft for your operating system.

6.Dual bay JBOD enclosure sees two separate drives instead of one big volume

Jumpers Please make sure to set the hardware JBOD or RAID 0 jumpers in appropriate position.

Caution: partitioning & formatting a drive will erase all data!

Drives with existing partitions In order for the JBOD and RAID 0 drive enclosures to combine two hard drives into one big volume, the two hard drives must not be “partitioned”. You must prepare both drives by deleting their partitions and power cycle the drive enclosure. Only then can the drive enclosure combine both drives into one big volume and recognizable to the operating system as one big volume.

Delete partitions To delete partition under Windows XP, right click on My Computer > click on Manage > click on Disk Management on the left panel. On the right hand side you should see a list of all drives connected to your computer. Find the two partitioned drive in black color, it should say for example "250 GB Healthy" and “500 GB Healthy”. Right click on it > click on Delete Partition > click on Yes to continue. Repeat for the second hard drive. When finished deleting partitions, power cycle the drive enclosure and follow the steps in Question # 2 to partition and format the new drive.

7. Delayed write failure

Powered USB hub Make sure you are using USB hub with adequate power supply. Low quality USB hubs usually draw power from the computer’s USB port and do not provide adequate power. Certain notebooks (mostly older notebooks) have underpowered USB ports and may require that you plug in additional USB cable to provide adequate power supply (the USB Y splitter cable is included with all portable 2.5” drive enclosures).

Eagle Electronics I My safely remove hardware icon is gone, Error deleting file or folder

Models: I

3. My “safely remove hardware” icon is gone

4. Error deleting file or folder

5. HI-speed device is plugged into a LO-speed USB port

7. Delayed write failure