Now
simply press
the key adjacent to the desired label. For
example, if
you
pressthe key adjacenttothe
"SMALL"
label,thedigital displays
are shown
in small numbers. (Note: The GPS
displays are
always
shown in small
numbers.)
The
large digital
selection erases the chart and shows the
digital displays
in large. Pressing the menu key gives only one menu page which is
different from other menus. This menu lets you go back to chart
information, placing the
digital display back in the medium
size, select
digital displays, and adjust the depth alarm. Returning to the chart
restores the normal menu operation.
SELECT DIG. SIZES n-
sa-
os
SONAR MENU
- PAGE 4
SELECT UNITS OF MEASURE
The UltraNavGPS can display
the water
depth in feet or
meters, surface
water
temperature in degrees Fahrenheit or Celsius, speed in statute
miles per
hour or
knots,
and distance (log)
in miles or nautical miles. This
menu switches all
displays
to their metric
equivalent and back
again. You
cannot switch each
display individually.
To
change
the units of
measure, first
press
the menu key
four times. The
screen at the
top
of the next
page appears. Next, press the
key adjacent
to the "SELECT UNITS OF MEASURE" label. The screen at the above
right appears. Now
pressthe keyadjacenttothe
"CHANGETO
METERS,
O, NAUTICAL MILES" label. The unit of measure
change to the
metric
equivalent. Repeat these steps
to switch the units of measure again.
PLOTTER The
plotter lets you see
your
course and direction of travel on the screen.
If you've recalled a waypoint, the plotter shows your starting location,
present position, and destination. However, you do not have to recall a
waypoint to use the
plotter.
To use the
plotter, simply press
the PLOT
key. A screen similar to the one
below appears. _____________________
The flashing
cross is your present position.
The solid line is
your
track, or path you have
just traveled. The circle is a compass rose
marked with North, South, East, and West.
The circle's radius
displays
at the top of the
screen. This is the distance from the centerto
the edge
of the circle. Your
present position
is shown at the bottom of the screen.
If
your present position
starts to move outside
of the circle, the UItraNavGPS clears the
display, then re-draws your present position
closer to the center of the screen. Your present position
will always
be
displayed
on the
plotter.
To clear the
plotter
screen, see
the Plotter Menus section.
Plotting with a Waypoint
Using the
plotter
with a recalled
waypoint or route is an
easy
wayto see the
effects of wind and current on your
boat. It also
simplifies navigation to a
fixed
point. To use the plotter in this manner,
first recall a
waypoint
or start a route. (Seethe
Waypoint Recall section for more informa-
tion.) Then press
the PLOT key. A screen
similar to the one below appears.
The "5" is your starting location. This was
your position
when
you
recalled the
waypoint.
The flashing
cross is your present position,
and the "0" is the destination (recalled way-
point). If you are using
a route, it's the first
waypoint in the route. The dotted line is the
shortest,
most direct course from the starting
point
to the destination. Follow this line to
get
to the waypoint.
'4 -I
1w •1 E
SMALL DIGITAL DISPLAY
i' E
24 49
PLOTTER SCREEN
PDF compression, OCR, web-optimization with CVISION's PdfCompressor