NOTES:
Surface Mounting
- With Access
If you have access underneath the mounting surface,
use the gasket
furnished with the GPS module as a template. Mark and drill four
5.5mm (7/32") holes for the mounting screws and one 14 mm (9/16")
hole for the module's cable. Attach the cable to the module and
pass it
down
through the hole in the gasket and the mounting surface. Use
four 5 mm screws, flat washers, and lock washers to fasten the OPS
module to the mounting surface. Route the 25' GPS cable to the
UltraNavGPS. 7
I y/////////////////// /////////////////////////////////////////A
SCREW
Surface Mounting - Without Access
If you don't have access to the back side of the mounting
surface,
use
the "cleats" supplied
with the UltraNavGPS. (Note: This is assuming
you can "snake" the module's cable to a location that is accessable. A
hole will still need to be drilled in the
mounting
surface for the cable.)
Using the
gasket as a template, mark and drill the 9/16" hole for the
cable. Attach
the cable to the module and drop the other end of the
cable
through
the
gasket and down the hole. Place the module on the
gasket. Slide the "cleats" onto each end of the module and (using the
cleats as templates) mark four holes for 5 mm (#10) mounting
screws.
Drill
the
holes,
then replace the cleats on the module and fasten them
to the mounting surface with 5 mm (#10) screws. Route the cable to
the UltraNavGPS.
4
PDF compression, OCR, web-optimization with CVISION's PdfCompressor