2.4Router Management
Selecting ROUTER MANAGEMENT from the main menu allows the user to configure the router. The router management screen is shown in Figure 5. Refer to Section 4 for details on each menu option.
+ | |
ROUTER: S1234 | EXIT |
+ | |
UNIT STATUS |
|
TRAFFIC ANALYSIS |
|
NETWORK LOADING |
|
REMOTE MANAGEMENT |
|
UNIT CONFIGURATION |
|
SERVICE SETUP |
|
FILTER SETUP |
|
EVENTS |
|
Figure 5 Router Management Screen
2.4.1 General Keyboard Conventions
The following keys are used to navigate the configuration screens for the router management.
«
»
Moves the cursor block to the right Moves the cursor block to the left Moves the cursor block upwards Moves the cursor block downwards
<return> | selects/initiates the highlighted option |
2.4.2 Parameter Selection
When a command is selected from the command line using the cursor, pressing <return> will initiate action.
Some commands require the user to enter data. In Figure 6, a user has selected to ADD a new WAN IP filter. A new line has appeared allowing the user to enter the source IP address for the WAN filter. In this case, type in the required value using the keyboard and press <return>. Press <esc> to cancel any data entry operation
Echo LANlink Router Option User Manual | Issue 1.0 04 December 1997 Page 11 of 59 |
