Echo EN55022 Use And Configuration, Router Configuration, Supervisor Terminal Requirements, login

2USE AND CONFIGURATION

This section covers connection and set-up of the Echo LANlink Router Option, and must be used in conjunction with the Echo LANlink User Manual. If you are not familiar with the general configuration procedure for the Echo LANlink, please refer to that manual before reading further and attempting to configure the Router Option.

2.1Router Configuration

The Router is initially configured using an asynchronous terminal, or PC using a suitable terminal emulation package such as Windows Terminal. The terminal should be connected via its serial port to the SUPERVISOR port on the rear of the Echo LANlink (see Echo LANlink User Manual).

2.2Supervisor Terminal Requirements

The terminal should be configured as follows:

8 bit character, no parity, one stop bit, speed 9.6Kbps,

2.3Router Terminal Display

After power up, the terminal will display the following message:

login:

Either type in the factory default login, mgr, or your login name if one has previously been set and press <return>. The system will also prompt for a password if one has been set - initially no password is required, but password protection of the router configuration system is imperative to reduce the risk of unauthorized changes. The set-up of a password is covered later.

The terminal will then display the following question.

Default terminal VT 100/220/320/420. OK (y or n)?

Echo LANlink Router Option User Manual Issue 1.0 04 December 1997 Page 9 of 59