Manuals / Brands / Lawn and Garden / Trimmer / Echo / Lawn and Garden / Trimmer

Echo HCA-265 throttle linkage and ignition leads

1 32

Download 32 pages, 1.35 Mb

10

NOTE

Gear Housing must be aligned properly with engine. Aligning center locating hole in driveshaft housing with center drive shaft bolt

B

A

(A)provides correct alignment.

5.Tighten two (2) drive shaft clamp bolts (B) securely.

6.Route throttle linkage and ignition lead assembly along shaft and clip as shown.

B

throttle linkage and ignition leads

1.Close choke and remove air filter cover.

2.Place throttle linkage (C) through adjustment fixture (D) and install wire end into large carburetor throttle swivel hole (E). Check throttle for freedom of movement and that wide open throttle / low idle extremes are adjusted properly. The throttle linkage must be adjusted by moving the adjustment fixture (D). Consult with your

Echo Dealer for correct adjustment procedure.

3.Connect 2 ignition stop leads (F, G) from throttle cable tubing to 2 ignition leads (F, G) on engine.

C

D

E

F

GH

4.Secure ignition leads against engine housing with clip (H).

5.Install air filter and cover.

H

Contents

11/09 Introduction the operator’s manual the safety manual Table of Contents Safety Manual Safety Symbols and Important Information international symbols personal condition and safety equipment Page Page equipment Emission Control (exhaust & evaporative) EPA 2010 and Later Hot Decal (near muffler) Description POWER HEAD THROTTLE HANDLE - FOR RIGHT HAND THROTTLE TRIGGER LOCKOUT STOP SWITCH HAND GUARD / BLADE LOCK Contents Assembly drive shaft/power head throttle linkage and ignition leads balance and adjust unit Operation fuel Fuel Requirements Two Stroke Oil Handling Fuel Mixing Instructions After use Storage adjusting cutting angle rotate cutter assembly starting cold engine starting warm engine stopping engine hedge trimming Maintenance skill level maintenance intervals air filter fuel filter spark plug cooling system exhaust system Spark Arrestor Screen Exhaust Port Cleaning carburetor adjustment Engine Break-In High Altitude Operation lubrication Blades Gear Housing Assembly Drive Shaft Assembly sharpening blades blade adjustment Troubleshooting Storage Specifications Warranty Statements Page Page Servicing Information parts/serial number service echo consumer product support warranty registration additional or replacement manuals