Shaft Hedge Clipper 27

Operator’s Manual

Storage

WARNING

During operation the muffler or catalytic muffler and surrounding cover become hot. Always keep exhaust area clear of flammable debris during transportation or when storing, otherwise serious property damage or personal injury may result.

IMPORTANT

Always store and transport shaft hedge clippers in a stable, horizontal position. Always install blade cover, and return cutting assembly to folded/locked position for travel/storage.

Long Term Storage (over 30 days)

Do not store your unit for a prolonged period of time (30 days or longer) without performing protective storage maintenance which includes the following:

1.Store unit in a dry, dust free place, out of the reach of children.

danger

Do not store in enclosure where fuel fumes may accumulate or reach an open flame or spark or serious personal injury may result.

2.Place the stop switch in the “OFF” position.

3.Remove accumulation of grease, oil, dirt and debris from exterior of unit.

4.Perform all periodic lubrication and services that are required.

5.Apply a light coating of clean 20W engine oil along entire length of blades and on blade bolts.

6.Install blade cover.

7.Tighten all the screws and nuts.

8.Drain the fuel tank completely and pull the recoil starter handle several times to remove fuel from the carburetor.

9.Remove the spark plug and pour 7 cc (1/4 oz.) of fresh, clean, two-stroke engine oil into the cylinder through the spark plug hole.

A.Place a clean cloth over the spark plug hole.

B.Pull the recoil starter handle 2-3 times to distrib- ute the oil inside the engine.

C.Observe the piston location through the spark plug hole. Pull the recoil handle slowly until the piston reaches the top of its travel and leave it there.

10.Install the spark plug (do not connect ignition cable).