Shaft Hedge Clipper 15 Operator’s Manual
3.Purge Bulb
Pump purge bulb (C) until fuel is visible and flows freely in the clear fuel tank return line. Pump bulb an additional 4 or 5 times.
4.Recoil Starter
Lay the unit on a flat area and keep movable attachment parts clear of all obstacles. Firmly grasp right hand grip and throttle trigger lockout with left hand and fully depress throttle trigger to wide open position. Rapidly pull recoil starter handle/rope (D) until engine fires (or maximum five [5] pulls).
5.Choke
After engine fires (or five [5] pulls), move choke lever back to
“Run” ( ) position. Hold throttle trigger and throttle trigger lockout fully depressed and pull recoil starter handle/rope until engine starts and runs. Release throttle trigger and allow unit to warm up at idle for several minutes.
NOTE
If engine does not start with choke in Run position after 5 pulls, repeat instructions 2 - 5.
6.Throttle Trigger
After engine warm up, gradually depress throttle trigger to increase engine RPM to operating speed.
B 
C 
D 
D
starting warm engine
The starting procedure is the same as Cold Start except DO NOT close the choke, and do not depress throttle trigger to wide open position.
WARNING
The attachment should not move at idle, otherwise serious personal injury may result.
A
| NOTE |
|
|
|
| If attachment moves, readjust carburetor according to “Carburetor |
|
|
|
| Adjustment” instructions in this manual or see your ECHO Dealer. |
|
|
|
|
|
|
|
|
1. | Stop Switch |
| C |
|
| Move stop switch button (A) away from the STOP position. |
|
| |
|
|
|
| |
2. | Purge Bulb |
| D |
|
| Pump purge bulb (C) until fuel is visible and flows freely in the |
|
| |
|
|
|
| |
|
|
|
| |
| “Clear” fuel return line. Pump bulb an addition 4 or 5 times. |
|
|
|
|
|
|
|
3.Recoil Starter
Lay the unit on a flat area and keep movable attachment parts clear of all obstacles. Rapidly pull recoil starter handle/rope (D) until engine fires.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.
D