Shaft Hedge Clipper | 9 |
Operator’s Manual |
Contents
Due to packaging restrictions, some assembly is required.
After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing parts. Use the contents list to check for missing parts.
____ | 1 | - | Power Head |
____ | 1 | - | Drive Shaft /Gear Case Assembly |
____ | 1 | - | Operators Manual |
____ | 1 | - | Hedge Clipper Safety Manual |
____ | 1 | - | Warranty Registration Card |
____ | 1 | - | Shoulder Harness |
____ | 1 | - | Blade Cover |
____ 1 - | |||
____ | 1 - | 4 mm Hex Wrench | |
____ | 1 - | 8 mm/10 mm Wrench |
Assembly
Tools Required: 4 mm hex wrench, 8mm x 10mm Open End Wrench, Screwdriver
Parts Required: Power Head, Drive Shaft/Gear Case Assembly, Front (Loop) Handle Assembly:
Loop Handle, Handle Mounting Bracket 5 x 35 mm screws (2)
drive shaft/power head
1.Stand power head upright on a level surface.
2.Loosen the two (2) drive shaft clamp bolts (B) at engine drive shaft clamp, and remove center drive shaft location bolt (A).
3.Carefully fit driveshaft assembly to engine making sure that inner drive shaft engages clutch mount.
4.Turn drive shaft housing until locating hole lines up with location hole in clamp and install center drive shaft location bolt (A).
BB
A