14

rotate cutter assembly

Always use the unit from the right-hand side of your body – NEVER from the left side. Rotate cutter assembly 180 degrees on driveshaft in order to avoid cutting directly above your head, and to avoid contact with hot muffler.

1.

Loosen gearcase clamping screw (A), hand guard clamping screw

 

 

 

C

 

(B), and remove gearcase locating screw (C).

B

 

A

2.

Rotate cutter assembly 180-degrees on driveshaft until locating

 

 

 

hole in driveshaft is visible through locating hole in gearcase.

 

 

3.Install gearcase locating screw (C), and securely tighten all hard- ware.

WARNING

Hedge Clipper blades are very sharp. Wear gloves to protect hands when rotating cutter assembly or serious personal injury may result.

WARNING

During operation, the complete unit, especially the drive shaft housing and gearcase may become too hot to touch. Avoid contact when rotating cutter assembly.

starting cold engine

NOTE

The blade cover is used for transportation and storage. Remove blade cover before using the unit.

WARNING

The attachment will operate immediately when the engine starts and could result in loss of control and possible serious injury. Keep movable parts of the attachment off the ground and away from objects that could become entangled or thrown.

1.Stop Switch

Move stop switch button (A) forward away from the STOP position.

2.Close Choke

Move choke lever (B) to Cold Start () Position.

A

B

C D