Shaft Hedge Clipper 23

Operator’s Manual

lubrication

Blades

Level 1.

Tools Required: Clean rag, brush , oil can

Parts Required: 20W Engine Oil (lubrication), 50-50 mixture of kerosene and 20W oil (cleaning)

WARNING

Always disconnect spark plug wire before servicing cutting at- tachment. Blades are very sharp. Wear gloves to protect hands, otherwise serious personal injury may result.

1.Brush loose debris from blade and coat both sides of blade with the 50-50 cleaning mixture.

2.Allow cleaning mixture to soften the remaining gummy residue then wipe it from the blade.

3.Apply clean oil to the entire length of the blade. Be certain the blade bolts are lubricated.

4.Wipe excess oil from the blade before putting the unit back in ser- vice.

Gear Housing Assembly

Level 2

Tools required: Grease gun, rag

Parts required: POWER BLENDXTM 14 oz. cartridge P/N 91015 or Lithium Based Grease

1.Clean dirt from grease fittings (A).

2.Carefully pump grease in each fitting (A). DO NOT force grease. Too much pressure will force grease past seals and cause damage. Apply 1-2 pumps of grease every 15-25 hours of operation.

A

A