10
5. Tighten two (2) drive shaft clamp bolts (B) securely. | B | A |
|
|
6.Route throttle linkage and ignition lead assembly along shaft and clip as shown.
B
1.Close choke and remove air filter cover.
2.Place throttle linkage (C) through adjustment fixture (D) and install wire end into large carburetor throttle swivel hole (E). Check throttle for freedom of movement and that wide open throttle / low idle extremes are adjusted properly. The throttle linkage must be adjusted by moving the adjustment fixture (D). Consult with your Echo Dealer for correct adjustment procedure.
3.Connect 2 ignition stop leads (F, G) from throttle cable tubing to 2 ignition leads (F, G) on engine.
C
D
F
G
E
H
4.Secure ignition leads against engine housing with clip (H).
5.Install air filter and cover.
H