Echo PE-265 Spark Arrestor Screen, Cylinder Exhaust Port, EXHAUST SYSTEM

POWER EDGER	19
OPERATOR'S MANUAL

IMPORTANT

DO NOT use a metal scraper to remove dirt from the cylinder fins.

5.Use brush to remove dirt from the cylinder fins.

6.Remove grass and leaves from the grid between the recoil starter and fuel tank.

7.Assemble components in reverse order.

EXHAUST SYSTEM

Spark Arrestor Screen

Level2.

Tools Required: Cross Head Screwdriver, 4mm Hex Wrench, Soft Metal Brush

Parts Required: Spark Arrestor Screen, Gasket

1.Remove two (2) muffler cover screws and muffler cover (A).

2.Place piston at Top Dead Center (TDC) to prevent carbon/dirt from entering cylinder.

3.	Remove spark arrestor screen (B), gasket (C) and exhaust guide (D)	A
	frommufflerbody.
4.	Clean carbon deposits from muffler components.

NOTE

When cleaning carbon deposit, be careful not to damage the catalytic element inside muffler.

5.Replace screen if it is cracked, plugged or has holes burned through.

6.Assemble components in reverse order.

C

DB

Cylinder Exhaust Port

Level3.

IMPORTANT

The cylinder exhaust port must be inspected and cleaned of excess carbon every 3 months or 90 hours of operation in order to maintain this engine within the emissions durability period. ECHO strongly recommends that you return your unit to your ECHO dealer for this important maintenance service.