POWER EDGER

17

OPERATOR'S MANUAL

 

 

 

AIR FILTER

Level1.

Tools required: 25 or 50 mm (1 or 2 in.) Cleaning brush

Parts required: Air Filter

1.Close choke (Cold Start Position []). This prevents dirt from entering the carburetor throat when the air filter is removed. Brush accumulated dirt from air cleaner area.

2.Remove air filter cover. Brush dirt from inside cover.

3.Remove air filter and lightly brush debris from filter. Replace filter if it is damaged, fuel soaked, very dirty, or the rubber sealing edges are deformed.

4.If filter can be reused, be certain it:

•Fits tightly in the air filter cavity.

•Is installed with the original side out.

5.Install air filter cover.

FUEL FILTER

Level1.

Tools required: 200-250 mm (8-10 in.) length of wire with one end bent into a hook, clean rag, funnel, and an approved fuel container.

Parts required: FuelFilter

WARNING

Fuel isVERYflammable. Use extreme care when mixing, storing or handling.

1.Use a clean rag to remove loose dirt from around fuel cap and empty fuel tank.

2.Use the “fuel line hook” to pull the fuel line and filter from the tank.

3.Remove the filter from the line and install the new filter.