POWER EDGER

21

OPERATOR'S MANUAL

 

 

 

DRIVE SHAFT LUBRICATION

Level1.

Tools required:

8 mm Open End Wrench, 4 mm Hex Wrench,

 

 

 

Clean rag

 

Parts Required:

ECHO LUBETM 8oz.(P/N91014)orLithiumBase

 

 

 

 

®

 

 

 

Grease.

 

 

 

A

 

 

 

1.

Loosen two (2) screws (A) and remove center locating screw (B).

 

 

Pull gear box and shield from drive shaft housing.

 

2.

Pull flexible cable from the drive shaft housing, wipe clean and

 

 

recoat with a thin coating [15 ml (1/2 oz.)] of grease.

 

3.

Slide the flexible cable back in the drive housing. DO NOT get

B

 

dirt on the flex cable.

 

 

4.Install the gear housing and shield assembly.

BLADE REPLACEMENT/LUBRICATION

Level1.

Tools Required: T-wrench, Locking Tool, Needle Nose Pliers, 13 mm Open End Wrench

Parts Required: ECHO® LUBETM 8oz.(P/N91014)orLithiumBase Grease,BladeP/N69601552632,splitpinP/N 90030020022

NOTE

Grease gear case every 15 - 25 hours of use. Replace blade when it is worn shorter than 6 inches. Remove blade and adapters before greasing to prevent damage to gear and bearings.

1.Shut engine off. Disconnect spark plug lead from spark plug.