8
1.POWER HEAD - Factory assembled. Includes the engine, clutch, fuel system, ignition system and starter.
2.THROTTLE TRIGGERLOCKOUT - This lever must be held during starting. Operation of the throttle trigger is prevented unless throttle trigger lockout lever is engaged.
3.STOP SWITCH - "Slide Switch" mounted on top of the throttle Trigger Housing. Move switch FORWARD to RUN,BACKtoSTOP.
4.FRONT HANDLE - The front handle can be repositioned for comfortable operation by loosening the screws and moving the handle.
5.DEBRIS SHIELD/FLAP - Mounted over the cutting attachment. Helps protect operator by deflecting debris produced during the edging operation.
6.BLADE - Rotates to provide cutting action.
7.WHEEL - Adjustable up/down, sets depth of blade.
8.DRIVE SHAFT ASSEMBLY - Contains a specially designed liner and the flexible drive shaft.
9.THROTTLE TRIGGER - Spring loaded to return to idle when released. When accelerating, press trigger gradually for best operating technique.
10.GRIP - Rear (right hand) handle.
11.SPARK PLUG - Provides spark to ignite fuel mixture.
12.TOP GUARD - Protects arm from the hot engine.
13.RECOILSTARTERHANDLE- Pull recoil handle slowly until starter engages, then quickly and firmly. DO NOT let handle snap back or damage to unit will occur.
14.
15.
16.FUELTANKCAP- Cover and seals fuel tank.
17.CHOKE - The choke control is located on the air filter case. Move lever to "COLD START" (
) to close choke for cold starting. Move lever to "RUN" (
) position to open choke.
18.
19.PURGE BULB - Pumping purge bulb before starting engine draws fresh fuel from the fuel tank, purging air from the carburetor. Pump purge bulb until fuel is visible and flows freely in the clear fuel tank return line. Pump purge bulb an additional 4 or 5 times.