POWER EDGER 9

OPERATOR'S MANUAL

CONTENTS

The ECHO product you purchased has been factory pre-assembled for your convenience. Due to packaging restrictions, some assembly may be necessary.

After opening the carton, check for damage. Immediately notify your retailer or ECHO Dealer of damaged or missing parts. Use the contents list to check for missing parts.

__ 1, Power Head

__ 1, Drive Shaft Assembly __ 1, Plastic Bag (Co-Pack) __ 1, Operator's Manual __ 1, Safety Manual

__ 1, Warranty Registration Card

__ 1, ECHO Emissions and Warranty Statement __ 1, Echo Power Blend X TM 2-stroke oil sample

__ 1,

Front Handle

__ 1,

Lower Bracket, Front Handle

__ 4,

5 x 35 mm screws

__ 4,

5 mm nuts*

__ 1,

T-Wrench

__ 2,

Split pin

__ 1, 4 mm Hexagon Wrench

__ 1,

Locking Tool

__ 1,

8 x 10 mm Spanner Wrench

__ 1,

Safety Glasses

* 5mm nuts may not be needed.

ASSEMBLY

Tools Required: 4 mm Hex Wrench, 8 x 10 mm Open-end Wrench

Parts Required: Power head, Drive Shaft Assembly

DRIVE SHAFT/POWER HEAD

1.Stand power head upright on a level surface.

2.Loosen the two (2) drive shaft clamp bolts (B) at engine drive shaft clamp, and remove center drive shaft location bolt (A).

3.Remove dust cap and carefully fit drive shaft assembly to engine making sure that inner drive shaft engages into clutch mount.

4.Turn drive shaft housing until locating hole lines up with location hole in clamp and install center drive shaft location bolt (A).

NOTE

Gear Housing must be aligned properly with engine. Aligning center locating hole in driveshaft housing with center drive shaft bolt (A) provides correct alignment.

B B

A