Eclipse - Fujitsu Ten CD3000 manual Setting examples, Volume level SVC setting, Loud

How to operate the AUDIO CONTROL

	Adjusts different volume levels for each
SVC (Source Volume	audio mode. When SVC is set, the	Decreases the SVC	Increases the SVC
	volume level can change as shown in the
Control)		setting level.	setting level.
	example settings in the table on the this
	page.
	The loudness control may be turned on to
	emphasize low and high frequencies at
LOUD	low volume levels.	Turn the loudness control ON/OFF.
	Loudness compensates for the apparent
	weakness of low and high frequencies at
	low volume by boosting the bass and
	treble levels.

Setting examples:

The volume for the initial FM mode (default value: 40) is used as a reference for storing the differences in volume that have been set for each audio mode.

Audio mode	FM	AM	CD
Default value	Reference	0	0
(Volume level)	(40)	(40)	(40)
SVC setting	Reference	SVC setting	SVC setting
(Volume level)	(40)	value	value
		+15 (55)	-10 (30)
When volume level in FM
mode is adjusted from 40	45	55 ➔ 60	30 ➔ 35
to 45
When volume level in CD
mode is adjusted from 35	45 ➔ 70	60 ➔ 80*	60
to 60
When volume level in AM
mode is adjusted from 80	70 ➔ 5	20	60 ➔ 0*
to 20

*:The volume levels can be set to a maximum of 80 and a minimum of 0. If you try to go past the maximum or minimum volume level, the level will not change. For the CD changer, SVC adjusts the volume using the setting value for the CD player.

The volume difference can be set within a range of -10 to +20.

ATTENTION

If the battery terminals have been disconnected because of vehicle maintenance, the SVC settings will return to their default values. If this happens, you will need to make the settings again.

IX

37