Eclipse - Fujitsu Ten CD3000 How to turn the security indicator on/off, Press the Func button

ESN security operating procedure

What happens if an incorrect CD is inserted?

After the 5th incorrect attempt, the

1 display reads [HELP] for five seconds.

After the [HELP] message will appear for five seconds, serial number will appear.

2 Press the [CD ] button to close the front panel.

Press the [FUNC] button, then the

3 button [6], and hold them for five seconds.

After the [SEC] message appears for two seconds, rolling code (six digit) will appear.

4 Press the [FUNC] button.

[DISC] flashes on the display.

You will have five more attempts to insert correct disc.

5 Insert the Key CD into the slot.

If the correct CD is inserted, an [OK] message will appear for two seconds and the CD will be ejected.

ATTENTION

•If an incorrect CD is inserted, an [ERR_ ] ("ERR" and error number) message will appear for two seconds, after which the CD will be ejected.

•This process cancels the protection for ESN equipment.

●Note ●

If after 5 tries the correct Key CD is not inserted, the display will read [CALL]; the equipment must be returned to Eclipse to be reset. In this case, please contact your Eclipse dealer for assistance.

Your Key CD can be easily forgotten. Write the album name in a reminder note (See page 63).

How to turn the security indicator on/off

Once ESN security is activated, the indicator flashes whenever the vehicle's ignition switch is turned off, warning potential thieves that the equipment is protected. However, if do not want this visible deterrent, it may be turned off.

With the equipment in standby,

1 press the [FUNC] button, then the button [2] and hold both for more than one second.

[IND. FLASH] or [IND.-----] appears

2 on the display.

[IND. FLASH] means the security indicator will flash when the vehicle's ignition switch is off, and [IND.-----]

means it will not. Repeat the above steps to reactivate the flash mode.

How to read the Electronic Serial Number

Check that the equipment is in

1 standby.

Press and hold the [FUNC] button,

2 then the button [4], and hold both for more than one second.

[ESN] appears on the display, followed by an eight-digit number; this number is your electronic serial number (ESN). You may use this number to identify your Eclipse CD3000 in the event of theft recovery.

VII

31